关于960的op件安装

op的塑胶件和铝件结合的对不对，如果是这样，固定用的螺丝被塑胶件挡住了，塑胶件是否要切短一些

[ 本帖最后由 goldeagle 于 2008-3-19 08:31 PM 编辑 ]

原帖由 goldeagle 于 2008-3-19 08:29 PM 发表
op的塑胶件和铝件结合的对不对，如果是这样，固定用的螺丝被塑胶件挡住了，塑胶件是否要切短一些296047296048

塑胶件是反方向装，应该是从内向外装入的。

塑胶件从内向外装，塑胶件还是会挡住固定用的螺丝，塑胶件是否要切短一些

不用! 跟說明書裝吧!

OP件安装没有说明书

高手请回答

看图～～～～

基米螺丝不用转穿胶套, 只是用基米顶紧便可, 不过那支PIN上的扁平位置要对准上基米的方向, 这样才可让基米顶紧那支PIN。

[ 本帖最后由 serpent 于 2008-3-28 09:08 PM 编辑 ]

谢谢我明白了 :em02:

960推出新零件。。。。。

New from Serpent, for owners of the 960-07, comes this upgrade set to bring your 1/8th scale chassis up to the latest 2008 specification. Supplied with the latest instruction manual, the set includes the new-machined chassis plate, as well as a front and rear upgrade set. The rear upgrade set includes the latest upper and lower wishbones as well as the new uprights and a-arms and the set also comes with the new axle bearings and other required hardware. The front upgrade set features the new front bearing blocks, lower wishbones, new anti-roll bar mounts and the lower hinge pins. The front and rear upgrade sets are also available to buy separately. The front upgrade set features the new front bearing blocks, lower wishbones, new anti-roll bar mounts and the lower hinge pins. The front and rear upgrade sets are also available to buy separately.

Click here to see the front and rear upgrade sets…

你们的960在那里玩?北京那里可以玩?